Vhr-4m P = 3.96mm connector JST price advantage
3.96mm pitch / disconnect crimp connector
This small, field proven printed circuit board connector is reliable and has a large current carrying capacity. It can be used with various signals, power supplies and output circuits in consumer electronics.
• proven box contact
• compact connector with large capacity
• safe access and installation
Specifications
• rated current: 10A AC, DC (awg#16)
• rated voltage: 250 V AC, DC
• temperature range: - 25 ˚ C to + 85 ˚ C (including temperature rise during use) (current)
• contact resistance: initial value / 10 m Ω maximum value.
Maximum value of / 20m Ω after environmental test.
• insulation resistance: 1000m Ω sensitive.
• withstand voltage: 1500 VAC / min
• applicable wire: AWG #22 to #16
• applicable PC board thickness: 1.6 mm
Note:
Do not branch in parallel current exceeding the rated current. If branch
Parallelism, current imbalance or other problems may occur. If absolutely
To branch such a large current in parallel, you must use contacts
Made of phosphor bronze. Design the circuit without causing imbalance and instability
Provide additional margin for each circuit.
*Refer to "general instructions and precautions for use"
"Terminals and connectors" at the end of this catalogue.
*Please contact JST for details.
*RoHS compliant.
standard
Approved e60389
Certified lr20812
R75122
This small, field proven printed circuit board connector is reliable and has a large current carrying capacity. It can be used with various signals, power supplies and output circuits in consumer electronics.
• proven box contact
• compact connector with large capacity
• safe access and installation
Specifications
• rated current: 10A AC, DC (awg#16)
• rated voltage: 250 V AC, DC
• temperature range: - 25 ˚ C to + 85 ˚ C (including temperature rise during use) (current)
• contact resistance: initial value / 10 m Ω maximum value.
Maximum value of / 20m Ω after environmental test.
• insulation resistance: 1000m Ω sensitive.
• withstand voltage: 1500 VAC / min
• applicable wire: AWG #22 to #16
• applicable PC board thickness: 1.6 mm
Note:
Do not branch in parallel current exceeding the rated current. If branch
Parallelism, current imbalance or other problems may occur. If absolutely
To branch such a large current in parallel, you must use contacts
Made of phosphor bronze. Design the circuit without causing imbalance and instability
Provide additional margin for each circuit.
*Refer to "general instructions and precautions for use"
"Terminals and connectors" at the end of this catalogue.
*Please contact JST for details.
*RoHS compliant.
standard
Approved e60389
Certified lr20812
R75122